How to Properly Configure Scenarios in ZP Schedule tab

[shThs]

Hi,

I am looking for guidance on how to properly setup the Schedule feature in ZP to some tasks. There are several settings with this feature, but I am not fully understanding the different scenarios that it offers. More specifically, how to properly set the parameters so it produces the outcome that I want.

For instance, one simple scenario I am looking for is for it to run Project X at Time X, only 1 time, then stop. The other scenario is for it to run Project X at Time X, only 1 time, but retry at least X times if it fails after two attempts.

Here is a screenshot of the settings I see, however, I have had some tasks failed because I may have not chosen the correct scenario - http://prntscr.com/ldozz3

 

[VladZen]

1)"run Project X at Time X, only 1 time, then stop"

2) "run Project X at Time X, only 1 time, but retry at least X times if it fails after two attempts?"
Scheduler can't be configured exacly like this, but you may stop executing depending on number of successful execution (see success count).
For example, execute without end but stop after X successful results.

 

[shThs]

Thanks. In the "Add number of attempts". Does 0 represent infinite attempts?