Zenno doesn't open more threads/ enough hardware resources

[Aronax]

I have a small template which scrapes some data (a few variables...like 5-6) and writes them down in a table which is binded to an .xlsx file...nothing fancy here...the template has just 150 kb and when I run it in PM, it finishes in about 5-6 seconds.

I need it to run with 30 threads but zenno is not able to do the job with more than 5-6 threads.

The sytem resources are more than enough: CPU load usually stays at 30% and it rarely pitches 50%. The ram memory never goes beyond 35%. (screenshot attached)

Why doesn't Zenno open more than 5-6 threads, although there are plenty of hardware resources?

Is this a bug?

PS: tried to tweak the 'Threads in one process' value. The default is 5. Raised it to 10...no differences. Dimnished it to 1...it's even worse...Zenno doesn't go beyond 4 threads.
Help, please

 

[rostonix]

It's not bug. Your templates finish faster then new start ) Try to extend time of execution. Maybe do several tasks within one execution

 

[Aronax]

It makes sense...Thanks a lot